SE-R/G20/NX Clutch


JGY Super Single Clutch and Flywheel combo
*16lbs
*includes flywheel
*includes special throwout bearing
*revs super fast
*get into power band sooner
*faster excelleration
*lower moment of enertia
*resurfaceable
*heavy diapham with a 2500lb clamp load
*nice pedal feel.........similar to our JGY-6puck
*Cera-Metalic material
*holds up to 400HP

and a great price at only $795.00


Motul GEAR 300 75W90, 1 liter, great for all Nissan transmissions and rear ends, EXCEPT if using a clutch-type LSD Unshearable oil film in extreme conditions. Stays in 90 grade after KRL 20 hours shear test. Very high lubricating power which decreases friction and wear. 90 grade at hot temperature to provide outstanding oil film resistance at hot temperature and/or to reduce transmission noise. Fluid at low temperature to allow easier gear shifting when the gearbox is cold. Less effort required on the gear lever to shift the gears. - $14.75


JGY-DRAG-se-r Clutch Hey, here we go again, brought it to the market. This kid will hold over 500ft/lbs of torque. We run it in our drag car. Surprising very little chatter and wow does it grab that power. This is for the serious Horsepower FWD SR car.

$339 yes! lower price 6-22-09



JGY Lightweight flywheel. Steel construction. 11 pounds, and better suited for higher HP powered cars 350 or more, this is what we run in our drag car - $249 ****Also, our flywheels don't trigger your check engine light, that's right, we use the correct number of teeth on the ring gear, so that crank angle sensor sees what it should


JGY Lightweight flywheel. Steel construction. 8.8 pounds, and better suited for street cars and racers, this is the flywheel for 90% of our consumers -$269 ****Also, our flywheels don't trigger your check engine light, that's right, we use the correct number of teeth on the ring gear, so that crank angle sensor sees what it should


JGY FWD Aluminum short shifter - $79 - Sentry 91-01 / 200sx 95-01 / NX1600-2000 91-93 / Maxima 95-99 / G20 91-96 & 99-00 (Factory B13 shifter shown above)


JGY-STREET-se-r Sprung 6 puck disk, 390ft/lb of torque - This is our "go to" clutch. We use it for JDM motor installs to Bluebird installs, to upgraded turbo installs. We take great pride in this clutch. This is probably one of the best clutches on the market for the Se-r.

$270


Wow, didn't think we could bring another? Well we did, this thing is awesome, and is priced even better than the one above. And holds 290ft/lbs of torque. If you want a replacement clutch with a marginally stronger pedal, long lasting clutch, then here you go.

$255


B14 style LSD for $750 & B14 style non LSD for $450...also B15 style LSD new in stock